D-Link DGS-3000 series - Config Authentication Server Failover; Show Authentication

DGS-3000 Series Layer 2 Managed Gigabit Switch CLI Reference Guide
141
DGS-3000-26TC:admin#show authorization
Command: show authorization
Authorization for Attributes: Enabled.
DGS-3000-26TC:admin#
14-4 config authentication server failover
Description
This command is used to configure authentication server failover function.
Format
config authentication server failover [local | permit | block]
Parameters
local - Uses local DB to authenticate the client.
permit - The client is always regarded as authenticated.
block - Blocks the client. This is the default.
Restrictions
Only Administrators, Operators and Power-Users can issue this command.
Example
Set authentication server auth fail over state:
DGS-3000-26TC:admin#config authentication server failover local
Command: config authentication server failover local
Success.
DGS-3000-26TC:admin#
14-5 show authentication
Description
This command is used to display the authentication server failover configuration.
Format
show authentication
Parameters
None.