DGS-3000 Series Layer 2 Managed Gigabit Switch CLI Reference Guide
20
10_full - Sets port speed to 10_full.
100_half - Sets port speed to 100_half.
100_full - Sets port speed to 100_full._
1000_full - Sets port speed to 1000_full. While set port speed to 1000_full,user should specify
master or slave mode for 1000BASE-T interface, and leave the 1000_full without any
master or slave setting for other interface.
master - Specifies that the port(s) will be set to master.
slave - Specifies that the port(s) will be set to slave.
flow_control - (Optional) Turns on or turns off the flow control on one or more ports by enabling
or disabling this function.
enable - Specifies that the flow control option will be enabled.
disable - Specifies that the flow control option will be disabled.
learning - (Optional) Turns on or turns off the MAC address learning on one or more ports.
enable - Specifies that the learning option will be enabled.
disable - Specifies that the learning option will be disabled.
state - (Optional) Enables or disables the specified port. If the specificed ports are in error-
disabled status, configure their state to enable will recover these ports from disabled to enable
state.
enable - Specifies that the port state will be enabled.
disable - Specifies that the port state will be disabled.
mdix - (Optional) The MDIX mode can be specified as auto, normal, and cross. If set to the
normal state, the port is in the MDIX mode and can be connected to PC NIC using a straight
cable. If set to the cross state, the port is in the MDI mode, and can be connected to a port (in
the MDIX mode) on another switch through a straight cable.
auto - Specifies that the MDIX mode for the port will be set to auto.
normal - Specifies that the MDIX mode for the port will be set to normal.
cross - Specifies that the MDIX mode for the port will be set to cross.
description - (Optional) Specifies the description of the port interface.
<desc 1-32> - Enter the port interface description. This value can be up to 32 characters long.
clear_description - (Optional) Specifies that the description field will be cleared.
Restrictions
Only Administrators and Operators can issue this command.
Example
To configure the ports:
DGS-3000-26TC:admin#config ports all medium_type copper speed auto
Command: config ports all medium_type copper speed auto
Success.
2-18 show ports
Description
This command is used to display the current configurations of a range of ports.
Format
show ports {<portlist>} {[description | err_disabled | details | media_type]}
To Next Page
Loading...
