D-Link DGS-3000 series - Chapter 18 Debug Software Command List

DGS-3000 Series Layer 2 Managed Gigabit Switch CLI Reference Guide
184
Chapter 18 Debug Software Command
List
debug error_log [dump | clear | upload_toTFTP {<ipaddr> <path_filename 64>}]
debug buffer [utilization | dump | clear | upload_toTFTP <ipaddr> <path_filename 64>]
debug output [module <module_list> | all] [buffer | console]
debug config error_reboot [enable | disable]
debug config state [enable | disable]
debug show error_reboot state
debug show status {module <module_list>}
18-1 debug error_log
Description
This command is used to dump, clear or upload the software error log to a TFTP server.
Format
debug error_log [dump | clear | upload_toTFTP {<ipaddr> <path_filename 64>}]
Parameters
dump - Displays the debug message of the debug log.
clear - Clears the debug log.
upload_toTFTP - Specifies to upload the debug log to a TFTP server specified by IP address.
<ipaddr> - (Optional) Specifies the IPv4 address of the TFTP server.
<path_filename 64> - (Optional) Specifies the DOS pathname on the TFTP server. It can be
a relative pathname or an absolute pathname. This value can be up to 64 characters long.
Restrictions
Only Administrators can issue this command.
Example
To dump the error log: