D-Link DGS-3000 series - Show Snmp View; Create Snmp

DGS-3000 Series Layer 2 Managed Gigabit Switch CLI Reference Guide
609
69-12 show snmp view
Description
This command is used to display the SNMP view record.
Format
show snmp view {<view_name 32>}
Parameters
<view_name 32> - Enter the view name to be displayed. The name can be up to 32 characters
long.
Restrictions
None.
Example
To show SNMP view:
DGS-3000-26TC:admin#show snmp view
Command: show snmp view
Vacm View Table Settings
View Name Subtree View Type
--------------------- ------------------------ ----------
view123 1.3.6 Included
restricted 1.3.6.1.2.1.1 Included
restricted 1.3.6.1.2.1.11 Included
restricted 1.3.6.1.6.3.10.2.1 Included
restricted 1.3.6.1.6.3.11.2.1 Included
restricted 1.3.6.1.6.3.15.1.1 Included
CommunityView 1 Included
CommunityView 1.3.6.1.6.3 Excluded
CommunityView 1.3.6.1.6.3.1 Included
Total Entries: 9
DGS-3000-26TC:admin#
69-13 create snmp
Description
This command is used to create a recipient of an SNMP trap operation.
Format
create snmp [host <ipaddr> | v6host <ipv6addr>] [v1 | v2c | v3 [noauth_nopriv | auth_nopriv
| auth_priv]] <auth_string 32>