D-Link DGS-3000 series - Show Gvrp

DGS-3000 Series Layer 2 Managed Gigabit Switch CLI Reference Guide
33
Format
config gvrp [timer {join < value 100-100000> | leave < value 100-100000> | leaveall <value
100-100000>} | nni_bpdu_addr [dot1d | dot1ad]]
Parameters
timer - Specifies that the GVRP timer parameter will be configured.
join - (Optional) Specifies the Join time will be set.
<value 100-100000> - Enter the time used here. This value must be between 100 and
100000.
leave - (Optional) Specifies the Leave time will be set.
<value 100-100000> - Enter the time used here. This value must be between 100 and
100000.
leaveall - (Optional) Specifies the LeaveAll time will be set.
<value 100-100000> - Enter the time used here. This value must be between 100 and
100000.
nni_bpdu_addr - Determines the BPDU protocol address for GVRP in service provide site. It can
use 802.1d GVRP address, 802.1ad service provider GVRP address or a user-defined
multicast address. The range of the user defined address is 0180C2000000 - 0180C2FFFFFF.
dot1d - Specifies that the NNI BPDU protocol address value will be set to Dot1d.
dot1ad - Specifies that the NNI BPDU protocol address value will be set to Dot1ad.
Restrictions
Only Administrators, Operators and Power-Users can issue this command.
Example
To set the Join time to 200 milliseconds:
DGS-3000-26TC:admin#config gvrp timer join 200
Command: config gvrp timer join 200
Success.
DGS-3000-26TC:admin#
3-16 show gvrp
Description
This command is used to display the GVRP global setting.
Format
show gvrp
Parameters
None.