D-Link DGS-3000 series - Show Snmp V6 Host

DGS-3000 Series Layer 2 Managed Gigabit Switch CLI Reference Guide
612
69-16 show snmp v6host
Description
This command is used to display the recipient for which the traps are targeted.
Format
show snmp v6host {<ipv6addr>}
Parameters
<ipv6addr> - (Optional) Enter the IPv6 host address used for the configuration here.
If no parameter specified, all SNMP hosts will be displayed.
Restrictions
None.
Example
To show SNMP host:
DGS-3000-26TC:admin#show snmp v6host
Command: show snmp v6host
SNMP Host Table
------------------------------------------------------------------
Host IPv6 Address : 3FFE::3
SNMP Version : V3 na/np
Community Name/SNMPv3 User Name : initial
Host IPv6 Address : 3FFE::2
SNMP Version : V2c
Community Name/SNMPv3 User Name : private
Host IPv6 Address : 3FFE::1
SNMP Version : V1
Community Name/SNMPv3 User Name : public
Host IPv6 Address : 3FFE::3
SNMP Version : V3 a/np
Community Name/SNMPv3 User Name : user123
Host IPv6 Address : 3FFE::3
SNMP Version : V3 a/ p
Community Name/SNMPv3 User Name : user234
Total Entries: 5
DGS-3000-26TC:admin#