D-Link DGS-3000 series - Show Cfm Ports

DGS-3000 Series Layer 2 Managed Gigabit Switch CLI Reference Guide
159
Format
config cfm ports <portlist> state [enable | disable]
Parameters
<portlist> - Enter the list of ports used for this configuration.
state - Specifies that the the CFM function will be enabled or disabled.
enable - Specifies that the CFM function will be enabled.
disable - Specifies that the CFM function will be disabled.
Restrictions
Only Administrators, Operators and Power-Users can issue this command.
Example
To configure the CFM ports:
DGS-3000-26TC:admin#config cfm ports 2-5 state enable
Command: config cfm ports 2-5 state enable
Success.
DGS-3000-26TC:admin#
16-13 show cfm ports
Description
This command is used to show the CFM state of specified ports.
Format
show cfm ports <portlist>
Parameters
<portlist> - Enter the list of logical ports.
Restrictions
None.
Example
To show the CFM ports: