D-Link DGS-3000 series - Config Temperature

DGS-3000 Series Layer 2 Managed Gigabit Switch CLI Reference Guide
514
Example
To configure the warning temperature threshold:
DGS-3000-26TC:admin#config temperature threshold high 80
Command: config temperature threshold high 80
Success.
DGS-3000-26TC:admin#
55-4 config temperature
Description
This command is used to configure the trap state for temperature warning event.
Format
config temperature [trap | log] state [enable | disable]
Parameters
trap state - Specifies the trap state for the warning temperature event.
enable - Enable trap state for warning temperature event. The default state is enabled.
disable - Disable trap state for warning temperature event.
log state - Specifies the log state for the warning temperature event.
enable - Enable log state for warning temperature event. The default state is enabled.
disable - Disable log state for warning temperature event.
Restrictions
Only Administrators and Operators can issue this command.
Example
To configure the warning temperature trap state:
DGS-3000-26TC:admin#config temperature trap state enable
Command: config temperature trap state enable
Success.
DGS-3000-26TC:admin#