D-Link DGS-3000 series - Chapter 82 VLAN Trunking Command List

DGS-3000 Series Layer 2 Managed Gigabit Switch CLI Reference Guide
687
Chapter 82 VLAN Trunking Command
List
enable vlan_trunk
disable vlan_trunk
config vlan_trunk ports [<portlist>|all] state [enable|disable]
show vlan_trunk
82-1 enable vlan_trunk
Description
This command is used to enable the VLAN trunk function. When the VLAN trunk function is
enabled, the VLAN trunk ports shall be able to forward all tagged frames with any VID.
Format
enable vlan_trunk
Parameters
None.
Restrictions
Only Administrators can issue this command.
Example
To enable the VLAN Trunk:
DGS-3000-26TC:admin#enable vlan_trunk
Command: enable vlan_trunk
Success.
DGS-3000-26TC:admin#
82-2 disable vlan_trunk
Description
This command is used to disable the VLAN trunk function.
Format
disable vlan_trunk