D-Link DGS-3000 series - Enable Snmp Traps; Disable Snmp Traps

DGS-3000 Series Layer 2 Managed Gigabit Switch CLI Reference Guide
617
69-24 enable snmp traps
Description
This command is used to enable SNMP trap support.
Format
enable snmp traps
Parameters
None.
Restrictions
Only Administrators and Operators can issue this command.
Example
To enable SNMP trap support:
DGS-3000-26TC:admin#enable snmp traps
Command: enable snmp traps
Success.
DGS-3000-26TC:admin#
69-25 disable snmp traps
Description
This command is used to disable SNMP trap support on the Switch.
Format
disable snmp traps
Parameters
None.
Restrictions
Only Administrators and Operators can issue this command.
Example
To prevent SNMP traps from being sent from the Switch: