D-Link DGS-3000 series - Config Accounting Service

DGS-3000 Series Layer 2 Managed Gigabit Switch CLI Reference Guide
79
5-33 config accounting service command
Description
This command is used to configure the state of the specified accounting service.
Format
config accounting service command {administrator | operator | power_user | user}
[method_list_name <string> | none]
Parameters
administrator - Accounting service for all administrator level commands.
operator - Accounting service for all operator level commands.
power_user - Accounting service for all power-user level commands.
user - Accounting service for all user level commands.
method_list_name - Specifies accounting service by the AAA user-defined method list specified
by the create accounting method_list_name <string 15> command.
<string> - Enter the name of the method list.
none - Disables AAA command accounting services by specified command level.
Restrictions
Only Administrators, Operators and Power-Users can issue this command.
Example
To enable AAA accounting methodlist “shell_acct” to configure accounting shell state:
DGS-3000-26TC:admin#config accounting service command method_list_name
shell_acct
Command: config accounting service command method_list_name shell_acct
Success.
DGS-3000-26TC:admin#
5-34 config accounting service
Description
This command is used to configure the state of the specified RADIUS accounting service.
Format
config accounting service [network | shell | system] state [enable {[radius_only |
method_list_name <string 15> | default_method_list]} | disable]
Parameters
network - Accounting service for 802.1X, JWAC and WAC port access control. By default, the
service is disabled.