D-Link DGS-3000 series - Show Lldp Ports

DGS-3000 Series Layer 2 Managed Gigabit Switch CLI Reference Guide
377
41-8 show lldp mgt_addr
Description
This command is used to display the LLDP management address information.
Format
show lldp mgt_addr {[ipv4 <ipaddr> | ipv6 <ipv6addr>]}
Parameters
ipv4 - (Optional) Specifies the IPv4 address used for the display.
<ipaddr> - Enter the IPv4 address used for this configuration here.
ipv6 - (Optional) Specifies the IPv6 address used for the display.
<ipv6addr> - Enter the IPv6 address used for this configuration here.
Restrictions
None.
Example
To display management address information:
DGS-3000-26TC:admin#show lldp mgt_addr ipv4 10.90.90.90
Command: show lldp mgt_addr ipv4 10.90.90.90
Address 1 :
------------------------------------------------
Subtype : IPv4
Address : 10.90.90.90
IF Type : IfIndex
OID : 1.3.6.1.4.1.171.10.133.2.1
Advertising Ports : 1-2,5
DGS-3000-26TC:admin#
41-9 show lldp ports
Description
This command is used to display the LLDP per port configuration for advertisement options.
Format
show lldp ports {<portlist>}
Parameters
<portlist> - (Optional) Specifies a range of ports to be displayed.
If the port list is not specified, information for all the ports will be displayed.