D-Link DGS-3000 series - Chapter 74 Telnet Client Command List

To Next Page

To Previous Page

DGS-3000 Series Layer 2 Managed Gigabit Switch CLI Reference Guide

652

Chapter 74

Telnet Client Command List

telnet [<ipaddr> | <domain_name 255> |<ipv6addr>] {tcp_port <value 1-65535>}

74-1 telnet

Description

This command is used to start the telnet client to connect to the specific telnet server. The

parameters specified by the command will only be used for the establishment of this specific

session. They will not affect the establishment of other sessions.

Format

telnet [<ipaddr> | <domain_name 255> |<ipv6addr>] {tcp_port <value 1-65535>}

Parameters

<ipaddr> - The IP address of the TLENET server.

<domain_name 255> - The domain name of the TLENET server.

<ipv6addr> - The IPv6 address of the telnet server.

tcp_port - (Optional) Specifies the Telnet server port number to be connected. If not specified,

the default port is 23.

<value 1-65535> - Enter the TCP port number used here. This value must be between 1 and

65535.

<ipaddr> - The IP address of the telnet server.

tcp_port - (Optional) Specifies the telnet server port number to be connected. If not specified, the

default port is 23.

<value 1-65535> - Enter the TCP port number used here. This value must be between 1 and

65535.

Restrictions

Only Administrators, Operators and Power-Users can issue this command.

Example

Telnet to a Switch by specifying the IP address:

DGS-3000-26TC:admin#telnet 10.90.90.90

Command: telnet 10.90.90.90

DGS-3000-26TC Gigabit Ethernet Switch

Command Line Interface

Firmware: Build 1.00.015

UserName:

Other manuals for D-Link DGS-3000 series