D-Link DGS-3000 series - Chapter 79 Traffic Segmentation Command List

DGS-3000 Series Layer 2 Managed Gigabit Switch CLI Reference Guide
678
Chapter 79 Traffic Segmentation
Command List
config traffic_segmentation [<portlist> | all] forward_list [null | all | <portlist>]
show traffic_segmentation {<portlist>}
79-1 config traffic_segmentation
Description
This command is used to configure the traffic segmentation.
Format
config traffic_segmentation [<portlist> | all] forward_list [null | all | <portlist>]
Parameters
<portlist> - Specifies a range of ports to be configured.
all - Specifies that all the ports will be used for this configuration.
forward_list - Specifies a range of port forwarding domain.
null - Specifies a range of port forwarding domain is null.
all – Specifies all ports to be configured.
<portlist> - Specifies a range of ports to be configured.
Restrictions
Only Administrators, Operators and Power-Users can issue this command.
Example
To configure traffic segmentation:
DGS-3000-26TC:admin#config traffic_segmentation 1-10 forward_list 11-15
Command: config traffic_segmentation 1-10 forward_list 11-15
Success.
DGS-3000-26TC:admin#
79-2 show traffic_segmentation
Description
This command is used to display current traffic segmentation table.
Format
show traffic_segmentation {<portlist>}