D-Link DGS-3000 series - Chapter 80 Trusted Host Command List

DGS-3000 Series Layer 2 Managed Gigabit Switch CLI Reference Guide
680
Chapter 80 Trusted Host Command List
create trusted_host [<ipaddr> | <ipv6addr> | network <network_address> | ipv6_prefix
<ipv6networkaddr>] {snmp | telnet | ssh | http | https | ping}
delete trusted_host [ipaddr <ipaddr> | ipv6address <ipv6addr> | network <network_address> |
ipv6_prefix <ipv6networkaddr > | all]
config trusted_host [<ipaddr> | <ipv6addr> | network <network_address> | ipv6_prefix
<ipv6networkaddr>] [add | delete] {snmp | telnet | ssh | http | https | ping | all}
show trusted_host
80-1 create trusted_host
Description
This command is used to create the trusted host. The switch allows you to specify up to ten IPv4
and IPv6 addresses that are allowed to manage the Switch via in-band SNMP, TELNET or WEB
based management software. These IPv4 or IPv6 addresses must be members of the
Management VLAN. If no IPv4 or IPv6 addresses are specified, then there is nothing to prevent
any IPv4 or IPv6 addresses from accessing the Switch, provided the user knows the Username
and Password.
When the access interface is not specified, the trusted host will be created for all interfaces.
Format
create trusted_host [<ipaddr> | <ipv6addr> | network <network_address> | ipv6_prefix
<ipv6networkaddr>] {snmp | telnet | ssh | http | https | ping}
Parameters
<ipaddr> - The IP address of the trusted host.
<ipv6addr> - The IPv6 address of the trusted host.
network - The network address of the trusted network. The form of network address is
xxx.xxx.xxx.xxx/y.
<network_address> - Enter the network address used here.
ipv6_prefix – Specifies that IPv6 prefix here.
<ipv6networkaddr> - Enter the IPv6 network address here.
snmp - (Optional) Specifies trusted host for SNMP.
telnet - (Optional) Specifies trusted host for TELENT.
ssh - (Optional) Specifies trusted host for SSH.
http - (Optional) Specifies trusted host for HTTP.
https - (Optional) Specifies trusted host for HTTPs.
ping - (Optional) Specifies trusted host for PING.
Restrictions
Only Administrators and Operators can issue this command.
Example
To create the trusted host: