DGS-3000 Series Layer 2 Managed Gigabit Switch CLI Reference Guide
566
to - Specifies that the above or following parameter will be mapped to the previously
mentioned parameter.
green - Specifies the result color of mapping to be green.
red - Specifies the result color of mapping to be red.
yellow - Specifies the result color of mapping to be yellow.
Restrictions
Only Administrators, Operators and Power-Users can issue this command.
Example
To configure the mapping of the DSCP priority to priority 1:
DGS-3000-26TC:admin#config dscp map 1-8 dscp_priority 1 to 1
Command: config dscp map 1-8 dscp_priority 1 to 1
Success.
To configure the global mapping of the DSCP priority to priority 1:
DGS-3000-26TC:admin#config dscp map dscp_priority 1 to 1
Command: config dscp map dscp_priority 1 to 1
Success.
62-18 show dscp map
Description
This command is used to show DSCP trusted port list and mapped color, priority and DSCP.
Format
show dscp map {<portlist>} [dscp_priority | dscp_dscp | dscp_color] {dscp <dscp_list>}
Parameters
<portlist> - (Optional) A range of ports to show. If no port is specified, all ports’ DSCP mapping
will be displayed.
dscp_priotity - Specifies a list of DSCP value to be mapped to a specific priority.
dscp_dscp - Specifies a list of DSCP value to be mapped to a specific DSCP.
dscp_color - Specifies a list of DSCP value to be mapped to a specific color.
dscp - (Optional) This specifies DSCP value that will be mapped.
<dscp_list> - Enter the DSCP list here.
To Next Page
Loading...
