D-Link DGS-3000 series - Chapter 84 Password Recovery Command List

DGS-3000 Series Layer 2 Managed Gigabit Switch CLI Reference Guide
703
Chapter 84 Password Recovery
Command List
enable password_recovery
disable password_recovery
show password_recovery
84-1 enable password_recovery
Description
This command is used to enable the password recovery mode.
Format
enable password_recovery
Parameters
None.
Restrictions
Only Administrators can issue this command.
Example
To enable the password recovery mode:
DGS-3000-26TC:admin#enable password_recovery
Command: enable password_recovery
Success.
DGS-3000-26TC:admin#
84-2 disable password_recovery
Description
This command is used to disable the password recovery mode.
Format
disable password_recovery