DGS-3000 Series Layer 2 Managed Gigabit Switch CLI Reference Guide
126
DGS-3000-26TC:admin#disable ipif newone
Command: disable ipif newone
Success.
10-18 show ipif
Description
This command is used to display an IP interface.
Format
show ipif {<ipif_name 12>}
Parameters
ipif_name - Specifies the name of the IP interface.
<ipif_name 12> - (Optional) Enter the IP interface name used here. This name can be up to
Restrictions
None.
Example
To display an IP interface:
DGS-3000-26TC:admin#show ipif
Command: show ipif
IP Interface : System
VLAN Name : default
Interface Admin State : Enabled
Link Status : LinkUp
IPv4 Address : 10.90.90.90/8 (Manual)
IPv4 State : Enabled
IPv6 State : Enabled
DHCP Option12 State : Disabled
DHCP Option12 Host Name :
Total Entries: 1
To Next Page
Loading...
