D-Link DGS-3000 series - Chapter 28 External Alarm Command List

DGS-3000 Series Layer 2 Managed Gigabit Switch CLI Reference Guide
246
Chapter 28 External Alarm Command
List
config external_alarm channel <value 1-2> message <sentence 1-128>
show external_alarm
28-1 config external_alarm channel
Description
This command is used to configure external alarm message for a channel.
Format
config external_alarm channel <value 1-2> message <sentence 1-128>
Parameters
<value 1-2> - Specifies the value of channel to be configured.
message - Specifies the message to be displayed on console, log and trap.
<sentence 1-128> - Enter the message to be displayed on console, log and trap.
Restrictions
Only Administrators and Operators can issue this command.
Example
To configure alarm message for channel 1:
DGS-3000-26TC:admin#config external_alarm channel 1 message External Alamr: UPS
is Exhausted.
Command: config external_alarm channel 1 message External Alamr: UPS is
Exhausted.
Success.
DGS-3000-26TC:admin#
28-2 show external_alarm
Description
This command is used to display the status of external alarm.
Format
show external_alarm