D-Link DGS-3000 series - Show Boot File

DGS-3000 Series Layer 2 Managed Gigabit Switch CLI Reference Guide
146
DGS-3000-26TC:admin#config configuration config.cfg boot_up
Command: config configuration config.cfg boot_up
Success.
DGS-3000-26TC:admin#
15-3 save
Description
This command is used to save the current configuration to a file.
Format
save {[config <pathname 64> | log | all]}
Parameters
config - (Optional) Specifies to save the configuration to a file.
<pathname64> - Specifies the absolute pathname on the device file system. If pathname is
not specified, it refers to the boot up configuration file.
log - (Optional) Specifies to save the log.
all - (Optional) Specifies to save the configuration and the log.
Restrictions
Only Administrators and Operators can issue this command.
Example
To save the configuration:
DGS-3000-26TC:admin#save config c:/3000.cfg
Command: save config c:/3000.cfg
Saving all configurations to NV-RAM.......... Done.
DGS-3000-26TC:admin#
15-4 show boot file
Description
This command is used to display the configuration file and firmware image assigned as boot up
files.
Format
show boot_file