D-Link DGS-3000 series - Disable Ipif

DGS-3000 Series Layer 2 Managed Gigabit Switch CLI Reference Guide
125
Format
enable ipif [<ipif_name 12> | all]
Parameters
ipif_name - Specifies the name of the IP interface.
<ipif_name 12> - Enter the IP interface name used here. This name can be up to 12
characters long.
all – Specifies that all the IP interfaces will be enabled.
Restrictions
Only Administrators, Operators and Power-Users can issue this command.
Example
To enable an IP interface:
DGS-3000-26TC:admin#enable ipif newone
Command: enable ipif newone
Success.
DGS-3000-26TC:admin#
10-17 disable ipif
Description
This command is used to disable an IP interface.
Format
disable ipif [<ipif_name 12> | all]
Parameters
ipif_name - Specifies the name of the IP interface.
<ipif_name 12> - Enter the IP interface name used here. This name can be up to 12
characters long.
all – Specifies that all the IP interfaces will be disabled.
Restrictions
Only Administrators, Operators and Power-Users can issue this command.
Example
To disable an IP interface: