D-Link DGS-3000 series - Show Tftp

DGS-3000 Series Layer 2 Managed Gigabit Switch CLI Reference Guide
661
sim_log_file - (Optional) Specifies the pathname supports “upload sim_ms log_toTFTP” function.
<path_filename 64> - Specifies the pathname supports “upload sim_ms log_toTFTP”
function.
Restrictions
Only Administrators, Operators and Power-Users can issue this command.
Example
To configure TFTP server:
DGS-3000-26TC:admin#config tftp server 10.90.90.10
Command: config tftp server 10.90.90.10
Success.
DGS-3000-26TC:admin#
To configure TFTP server and specify the pre defined firmware file, log file:
DGS-3000-26TC:admin#config tftp server 10.90.90.1 firmware_file DGS3000.had
cfg_file log_tmp
Command: config tftp server 10.90.90.1 firmware_file DGS3000.had cfg_file
log_tmp
Success.
DGS-3000-26TC:admin#
75-4 show tftp
Description
This command is used to show the TFTP server and the file path pre-configured by administer.
Format
show tftp
Parameters
None.
Restrictions
None.
Example
To show TFTP settings, if pre-configure server IPv4 address, firmware_file and cfg_file only: