D-Link DGS-3000 series - Show Sntp; Enable Sntp

DGS-3000 Series Layer 2 Managed Gigabit Switch CLI Reference Guide
664
DGS-3000-26TC:admin#config sntp primary 10.1.1.1 secondary 10.1.1.2 poll-
interval 30
Command: config sntp primary 10.1.1.1 secondary 10.1.1.2 poll-interval 30
Success.
DGS-3000-26TC:admin#
76-2 show sntp
Description
This command is used to display SNTP current time source and configuration.
Format
show sntp
Parameters
None.
Restrictions
None.
Example
To show SNTP:
DGS-3000-26TC:admin#show sntp
Command: show sntp
Current Time Scource : System Clock
SNTP : Disabled
SNTP Primary Server : 10.1.1.1
SNTP Secondary Server : 10.1.1.2
SNTP Poll Interval : 30 sec
DGS-3000-26TC:admin#
76-3 enable sntp
Description
This command is used to turn on SNTP support.
Format
enable sntp