D-Link DGS-3000 series - Config Dscp Trust

DGS-3000 Series Layer 2 Managed Gigabit Switch CLI Reference Guide
562
DGS-3000-26TC:admin#show 802.1p default_priority 1-10
Command: show 802.1p default_priority 1-10
Port Priority Effective Priority
---- ----------- ------------------
1 5 5
2 5 5
3 5 5
4 5 5
5 5 5
6 5 5
7 5 5
8 5 5
9 5 5
10 5 5
DGS-3000-26TC:admin#
62-13 config dscp trust
Description
This command is used to configure the state of DSCP trust per port. When DSCP is not trusted,
802.1p is trusted.
Format
config dscp trust [<portlist> | all] state [enable | disable]
Parameters
<portlist> - Enter the list of port used for this configuration.
all - Specifies that the command apply to all ports on the Switch.
state - Specifies to enable or disable to trust DSCP. By default, DSCP trust is disabled.
enable - Specifies to enable the DSCP trust state.
disable - Specifies to disable the DSCP trust state.
Restrictions
Only Administrators, Operators and Power-Users can issue this command.
Example
Enable DSCP trust on ports 1-8.
DGS-3000-26TC:admin#config dscp trust 1-8 state enable
Command: config dscp trust 1-8 state enable
Success.
DGS-3000-26TC:admin#