D-Link DGS-3000 series - Debug Stp Clear Counter

DGS-3000 Series Layer 2 Managed Gigabit Switch CLI Reference Guide
453
Restrictions
Only Administrators can issue this command.
Example
To show the STP counters for port 9:
DGS-3000-26TC:admin#debug stp show counter ports 9
Command: debug stp show counter ports 9
STP Counters
--------------------------------------
Port 9 :
Receive: Transmit:
Total STP Packets : 0 Total STP Packets : 0
Configuration BPDU : 0 Configuration BPDU : 0
TCN BPDU : 0 TCN BPDU : 0
RSTP TC-Flag : 0 RSTP TC-Flag : 0
RST BPDU : 0 RST BPDU : 0
Discard:
Total Discarded BPDU : 0
Global STP Disabled : 0
Port STP Disabled : 0
Invalid packet Format : 0
Invalid Protocol : 0
Configuration BPDU Length : 0
TCN BPDU Length : 0
RST BPDU Length : 0
Invalid Type : 0
Invalid Timers : 0
CTRL+C ESC q Quit SPACE n Next Page p Previous Page r Refresh
48-5 debug stp clear counter
Description
This command is used to clear the STP counters.
Format
debug stp clear counter {ports[<portlist> | all]}
Parameters
ports – (Optional)Specifies the port range.
<portlist> - Enter the list of port used for this configuration here.
all - Clears all port counters.