D-Link DGS-3000 series - Page 173

DGS-3000 Series Layer 2 Managed Gigabit Switch CLI Reference Guide
169
DGS-3000-26TC:admin#show cfm mipccm
Command: show cfm mipccm
MA VID MAC Address Port
---------- ---- ----------------- -----
opma 1 xx-xx-xx-xx-xx-xx 2
opma 1 xx-xx-xx-xx-xx-xx 3
Total: 2
DGS-3000-26TC:admin#
16-22 config cfm mp_ltr_all
Description
This command is used to enable or disable the "all MPs reply LTRs" function.
Format
config cfm mp_ltr_all [enable | disable]
Parameters
enable - Specifies that the MP's reply to the LTR function will be set to all.
disable - Disables sending the all MPs replay LTRs function.
Restrictions
Only Administrators, Operators and Power-Users can issue this command.
Example
To enable the "all MPs reply LTRs" function:
DGS-3000-26TC:admin#config cfm mp_ltr_all enable
Command: config cfm mp_ltr_all enable
Success.
DGS-3000-26TC:admin#
16-23 show cfm mp_ltr_all
Description
This command is used to show the current configuration of the "all MPs reply LTRs" function.
Format
show cfm mp_ltr_all