D-Link DGS-3000 series - Page 196

DGS-3000 Series Layer 2 Managed Gigabit Switch CLI Reference Guide
192
19-2 config dhcp_local_relay vlan vlanid
Description
This command is used to enable or disable DHCP local relay function for specified VLAN ID.
Format
config dhcp_local_relay vlan vlanid <vlan_id> state [enable | disable]
Parameters
vlanid - Specifies the VLAN ID.
<vlan_id> - Enter the VLAN ID used here.
state - Enables or disables DHCP local relay for specified vlan.
enable - Specifies that the DHCP local relay function will be enabled.
disable - Specifies that the DHCP local relay function will be disabled.
Restrictions
Only Administrators, Operators and Power-Users can issue this command.
Example
To enable DHCP local relay for default VLAN:
DGS-3000-26TC:admin#config dhcp_local_relay vlan vlanid 1 state enable
Command: config dhcp_local_relay vlan vlanid 1 state enable
Success.
DGS-3000-26TC:admin#
19-3 config dhcp_local_relay option_82 circuit_id
Description
This command is used to configure the circuit id of DHCP relay agent information option 82 of the
switch.
Format
config dhcp_local_relay option_82 circuit_id [default | vendor1]
Parameters
default – Specifies the cirecuit id of DHCP relay agent to default.
vendor1 - Specifies the cirecuit id of DHCP relay agent to vendor1.
Restrictions
Only Administrators, Operators and Power-Users can issue this command.