D-Link DGS-3000 series - Page 20

DGS-3000 Series Layer 2 Managed Gigabit Switch CLI Reference Guide
16
Format
config greeting_message {default}
Parameters
default - (Optional) Adds this parameter to the config greeting_message command will return
the greeting message (banner) to its original factory default entry.
Restrictions
Only Administrators and Operators can issue this command.
Example
To edit the banner:
DGS-3000-26TC:admin#config greeting_message
Command: config greeting_message
Greeting Messages Editor
================================================================================
DGS-3000-26TC Gigabit Ethernet Switch
Command Line Interface
Firmware: Build 1.00.015
Copyright(C) 2013 D-Link Corporation. All rights reserved.
================================================================================
<Function Key> <Control Key>
Ctrl+C Quit without save left/right/
Ctrl+W Save and quit up/down Move cursor
Ctrl+D Delete line
Ctrl+X Erase all setting
Ctrl+L Reload original setting
--------------------------------------------------------------------------------
2-13 show greeting_message
Description
The command is used to display greeting message.
Format
show greeting_message
Parameters
None.