D-Link DGS-3000 series - Page 213

DGS-3000 Series Layer 2 Managed Gigabit Switch CLI Reference Guide
209
Restrictions
None.
Example
To show DHCP option 60 information:
DGS-3000-26TC:admin#show dhcp_relay option_60
Command: show dhcp_relay option_60
Default Processing Mode: Drop
Default Servers:
Matching Rules:
String Match Type IP Address
------- --------- ---------
abc Exact Match 10.90.90.1
Total Entries : 1
DGS-3000-26TC:admin#
20-16 config dhcp_relay option_61
Description
This command is used to decide whether the DHCP relay will process the DHCP option 61 or not.
When option 61 is enabled, if the packet does not have option 61, then the relay servers cannot be
determined based on option 61.
If the relay servers are determined based on option 60 or option 61, then per IPIF configured
servers will be ignored.
If the relay servers are not determined either by option 60 or option 61, then per IPIF configured
servers will be used to determine the relay servers.
Format
config dhcp_relay option_61 state [enable | disable]
Parameters
state - Specifies whether the DHCP relay option 61 is enabled or disabled.
enable - Enables the function DHCP relay use option 61 ruler to relay DHCP packet.
disable - Disables the function DHCP relay use option 61 ruler to relay DHCP packet.
Restrictions
Only Administrators, Operators and Power-Users can issue this command.