D-Link DGS-3000 series - Page 319

DGS-3000 Series Layer 2 Managed Gigabit Switch CLI Reference Guide
315
34-15 show address_binding dhcp_snoop binding_entry
Description
This command is used to display the DHCP snooping binding entries.
Format
show address_binding dhcp_snoop binding_entry {port <port>}
Parameters
port – (Optional) Specifies the port used for this configuration.
<port> - Enter the port number used here.
Restrictions
None.
Example
To display the DHCP snooping binding entries:
DGS-3000-26TC:admin#show address_binding dhcp_snoop binding_entry
Command: show address_binding dhcp_snoop binding_entry
S (Status) - A: Active, I: Inactive
Time - Left Time (sec)
IP Address MAC Address S Time Port
--------------------------------------- --------------------- -- ----- ------
10.62.58.35 00-0B-5D-05-34-0B A 35964 1
10.33.53.82 00-20-c3-56-b2-ef I 2590 2
Total entries : 2
DGS-3000-26TC:admin#
34-16 config address_binding dhcp_snoop max_entry
Description
This command is used to specify the maximum number of entries that can be learned by a
specified port.
Format
config address_binding dhcp_snoop max_entry ports [<portlist> | all] limit [<value 1-50> |
no_limit] {ipv6}