DGS-3000 Series Layer 2 Managed Gigabit Switch CLI Reference Guide
323
34-27 no debug address_binding
Description
This command is used to stop the IMPB debug starting when the IMPB module receives an
ARP/IP packet or a DHCP packet.
Format
no debug address_binding
Parameters
None.
Restrictions
Only Administrator users can issue this command.
Example
To stop IMPB debug: starting when the IMPB module receives an ARP/IP or DHCP packet:
DGS-3000-26TC:admin#no debug address_binding
Command: no debug address_binding
Success.
34-28 enable address_binding roaming
Description
This command is used to enable the IMPB roaming.
Format
enable address_binding roaming
Parameters
None.
Restrictions
Only Administrators, Operators and Power-Users can issue this command.
Example
To enable the IMPB roaming:
To Next Page
Loading...
