D-Link DGS-3000 series - Page 34

DGS-3000 Series Layer 2 Managed Gigabit Switch CLI Reference Guide
30
3-11 show port_vlan
Description
This command is used to display the ports’ VLAN attributes on the Switch.
Format
show port_vlan {<portlist>}
Parameters
<portlist> - (Optional) Specifies a range of ports to be displayed.
If no parameter specified, system will display all ports gvrp information.
Restrictions
None.
Example
To display 802.1Q port setting:
DGS-3000-26TC:admin#show port_vlan
Command: show port_vlan
Port PVID GVRP Ingress Checking Acceptable Frame Type
------- ---- -------- ---------------- ---------------------------
1 2 Enabled Enabled Only VLAN-tagged Frames
2 2 Enabled Enabled Only VLAN-tagged Frames
3 2 Enabled Enabled Only VLAN-tagged Frames
4 2 Enabled Enabled Only VLAN-tagged Frames
5 2 Enabled Enabled Only VLAN-tagged Frames
6 1 Disabled Enabled All Frames
7 1 Disabled Enabled All Frames
8 1 Disabled Enabled All Frames
9 1 Disabled Enabled All Frames
10 1 Disabled Enabled All Frames
11 1 Disabled Enabled All Frames
12 1 Disabled Enabled All Frames
13 1 Disabled Enabled All Frames
14 1 Disabled Enabled All Frames
15 1 Disabled Enabled All Frames
16 1 Disabled Enabled All Frames
17 1 Disabled Enabled All Frames
18 1 Disabled Enabled All Frames
19 1 Disabled Enabled All Frames
20 1 Disabled Enabled All Frames
CTRL+C ESC q Quit SPACE n Next Page ENTER Next Entry a All