D-Link DGS-3000 series - Page 497

DGS-3000 Series Layer 2 Managed Gigabit Switch CLI Reference Guide
493
52-2 config nlb unicast_fdb
Description
This command is used to add or delete the forwarding ports for the specified NLB unicast FDB
entry.
Format
config nlb unicast_fdb <macaddr>[add|delete]<portlist>
Parameters
<macaddr> - Specifies the MAC address of the NLB unicast FDB entry to be configured.
add - Specifies to add the ports.
delete - Specifies to delete the ports.
<portlist> - Specifies a list of forwarding ports to be added or removed.
Restrictions
Only Administrators, Operators and Power-Users can issue this command.
Example
To configure NLB unicast FDB entry, for the product that support the VLAN information on the
unicast forwarding:
DGS-3000-26TC:admin#config nlb unicast_fdb 02-bf-01-01-01-01 add 1-5
Command: config nlb unicast_fdb 02-BF-01-01-01-01 add 1-5
Success.
DGS-3000-26TC:admin#
52-3 delete nlb unicast_fdb
Description
This command is used to delete the NLB unicast FDB entry.
Format
delete nlb unicast_fdb <macaddr>
Parameters
<macaddr> - Specifies the MAC address of the NLB unicast FDB entry to be deleted.
Restrictions
Only Administrators, Operators and Power-Users can issue this command.