D-Link DGS-3000 series - Page 630

DGS-3000 Series Layer 2 Managed Gigabit Switch CLI Reference Guide
626
70-2 disable sim
Description
This command is used to disable single IP management on the Switch.
Format
disable sim
Parameters
None.
Restrictions
Only Administrators, Operators and Power-Users can issue this command.
Example
To disable SIM:
DGS-3000-26TC:admin#disable sim
Command: disable sim
Success.
DGS-3000-26TC:admin#
70-3 show sim
Description
This command is used to display the current information of the specific sort of devices.
Format
show sim {[candidates {<candidate_id 1-100>} | members{<member_id 1-32>} | group
{commander_mac <macaddr>} | neighbor]}
Parameters
candidates - (Optional) Specifies the candidate devices.
<candidate_id 1-100> - (Optional) Enter the candidate device ID here. This value must be
between 1 and 100.
members - (Optional) Specifies the member devices.
<member_id 1-32> - (Optional) Enter the member device ID here. This value must be
between 1 and 32.
group - (Optional) Specifies other group devices.
commander_mac - (Optional) Specifies the commander MAC address used.
<macaddr> - Enter the commander MAC address used here.
neighbor - (Optional) Specifies other neighbor devices.