D-Link DGS-3000 series - Page 680

DGS-3000 Series Layer 2 Managed Gigabit Switch CLI Reference Guide
676
DGS-3000-26TC:admin#show traffic control 1-10
Command: show traffic control 1-10
Traffic Control Trap : [Both]
Traffic Control Log : Enabled
Traffic Control Auto Recover Time: 0 Minutes
Port Thres Broadcast Multicast Unicast Action Count Time Shutdown
hold Storm Storm Storm down Interval Forever
---- ------ --------- --------- -------- -------- -------- -------- --------
1 1 Enabled Disabled Disabled shutdown 5 10
2 1 Enabled Disabled Disabled shutdown 5 10
3 1 Enabled Disabled Disabled shutdown 5 10
4 1 Enabled Disabled Disabled shutdown 5 10
5 1 Enabled Disabled Disabled shutdown 5 10
6 1 Enabled Disabled Disabled shutdown 5 10
7 1 Enabled Disabled Disabled shutdown 5 10
8 1 Enabled Disabled Disabled shutdown 5 10
9 1 Enabled Disabled Disabled shutdown 5 10
10 1 Enabled Disabled Disabled shutdown 5 10
DGS-3000-26TC:admin#
78-4 config traffic control log state
Description
This command is used to configure the traffic control log state. When the log state is enabled,
traffic control states are logged when a storm occurs and when a storm is cleared. If the log state
is disabled, traffic control events are not logged.
Note: The log state is only applicable for shutdown mode. Since shutdown mode only support
broadcast and multicast storm control, doesn’t support unicast storm control. The log only
generate for broadcast and multicast storm control.
Format
config traffic control log state [enable | disable]
Parameters
enable - Both occurred and cleared are logged.
disable - Neither occurred nor cleared is logged.
Restrictions
Only Administrators, Operators and Power-Users can issue this command.
Example
To configure the traffic log state on the Switch: