To Next Page

To Previous Page

xStack® DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch CLI Reference Guide

761

guest VLAN mode, please see the description for configuring the MAC-based access control port

command.

Format

config mac_based_access_control guest_vlan ports <portlist>

Parameters

<portlist> - When a port is configured as gurest VLAN member port, this port will move to guest

VLAN if it’s MAC-based access control state is enable.

Restrictions

Only Administrators, Operators and Power-Users can issue this command.

Example

To configure the MAC-based access control guest VLAN membership for port 1 to 8:

DGS-3620-28PC:admin# config mac_based_access_control guest_vlan ports 1-8

Command: config mac_based_access_control guest_vlan ports 1-8

Success.

DGS-3620-28PC:admin#

65-6 config mac_based_access_control ports

Description

This command is used to configure the MAC-based access control setting. When the MAC-based

access control function is enabled for a port, and the port is not a MAC-based access control guest

VLAN member, the user who is attached to this port will not be forwarded unless the user passes

the authentication. A user that does not pass the authentication will not be serviced by the switch.

If the user passes the authentication, the user will be able to forward traffic operated under the

assigned VLAN.

When the MAC-based access control function is enabled for a port, and the port is a MAC-based

access control guest VLAN member, the port(s) will be removed from the original VLAN(s)

member ports, and added to MAC-based access control guest VLAN member ports. Before the

authentication process starts, the user is able to forward traffic under the guest VLAN. After the

authentication process, the user will be able to access the assigned VLAN.

If the port authorize mode is port based mode, when the port has been moved to the authorized

VLAN, the subsequent users will not be authenticated again. They will operate in the current

authorized VLAN. If the port authorize mode is host based mode, then each user will be authorized

individually and be capable of getting its own assigned VLAN.

D-Link xStack DGS-3620 Series User Manual

Questions and Answers: