D-Link xStack DGS-3620 Series User Manual

xStack® DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch CLI Reference Guide
814
Example
To display all MLD snooping multicast VLANs:
DGS-3620-28PC:admin# show mld_snooping multicast_vlan
Command: show mld_snooping multicast_vlan
MLD Multicast VLAN Global State : Enabled
MLD Multicast VLAN Forward Unmatched : Disabled
MLD Multicast VLAN Auto Assign VLAN : Enabled
VLAN Name :4094
VID :4094
Member(Untagged) Ports :2:20-2:21
Tagged Member Ports :
Source Ports :
Untagged Source Ports :2:22
Status :Enabled
Replace Source IP :FE80::1:1 (User Configure)
Remap Priority :6 (Replaced)
Total Entries: 1
DGS-3620-28PC:admin#
70-13 config mld_snooping multicast_vlan forward_unmatched
Description
This command is used to configure the forwarding mode for MLD snooping multicast VLAN
unmatched packets. When the switch receives an MLD snooping packet, it will match the packet
against the multicast profile to determine which multicast VLAN to associate with. If the packet
does not match all profiles, the packet will be forwarded in the natural VLAN of the packet, or
dropped based on this setting. By default, the packet will be dropped.
Format
config mld_snooping multicast_vlan forward_unmatched [disable | enable]
Parameters
enable - The packet will be flooded on the VLAN.
disable - The packet will be dropped.
Restrictions
Only Administrators, Operators and Power-Users can issue this command.
Example
To configure the forwarding mode for MLD snooping multicast VLAN unmatched packets:

D-Link xStack DGS-3620 Series Specifications

General

Brand	D-Link
Model	xStack DGS-3620 Series
Category	Switch
Language	English