Product Reference Guide 249
Appendix B
Standard Defaults
The most common configuration settings are listed in the “Default” column of
Table 25
. The
settings in this table are as applied to a standard RS-232 interface. See
Table 26
for a listing of
default exceptions to this list as applied to other interface types. Page references are also
provided for feature descriptions and programming bar codes for each parameter. A column
has also been provided for recording of your preferred default settings for these same
configurable features.
Table 25. Standard Defaults
Parameter Default Your Setting
Page Num-
ber
GLOBAL INTERFACE FEATURES
Host Commands — Obey/Ignore
Obey
17
USB Suspend Mode
Disable
18
RS-232
Baud Rate
115200
19
Stop Bits
1 Stop Bit
20
Parity
None
21
Handshaking Control
Disable
22
RS-232/USB-COM
Intercharacter Delay
No Delay
23
Beep On ASCII BEL
Disable
24
Beep On Not on File
Enable
24
ACK Character
‘ACK’
26
NAK Character
‘NAK’
26
ACK NAK Timeout Value
600 ms
27
ACK NAK Retry Count
3 Retries
28
ACK NAK Error Handling
Ignore Errors
Detected
29
Indicate Transmission Failure
Enable
30
To Next Page
Loading...
Need help?
General
