Datalogic 2 of 5 Enter/Exit Programming Mode
Product Reference Guide
143
Datalogic 2 of 5 Set Length 1
This feature specifies one of the bar code lengths for Datalogic 2 of 5 Length Control.
Length 1 is the minimum label length if in
Variable Length Mode, or the first fixed length if in
Fixed Length Mode. The length includes the bar code’s data characters only.
The length can be set from 2 to 50 charac
ters in increments of two. See "Set Length 1" on
page 239 for more detailed programming instructions.
Select Datalogic 2 of 5 Length 1 Setting
To configure this feature, scan the ENTER/EXIT bar
cod
e above, then the bar code at left followed by dig-
its from the Alphanumeric characters in
Appendix D,
Keypad
representing your desired character(s). End
by scanning the ENTER/EXIT bar code again.
Make a mistake? Scan the CANCEL bar code
to abort
and not save the entry string. You can then start
again at the beginning.
CANCEL
DEFAULT
06 = Length 1 is 6 Characters
$CD2L1
~
To Next Page
Loading...
