Wedge Quiet Interval Enter/Exit Programming Mode
Product Reference Guide
39
Wedge Quiet Interval
This option specifies the amount of time to look for keyboard activity before the scanner
breaks the keyboard connection in order to transmit data to host. The selectable range for this
feature is from 0 to 990ms in 10ms increments. See
"Wedge Quiet Interval" on page 226 for
more detailed programming instructions.
NOTE
Select Wedge Quiet Interval Setting
To configure this feature, scan the ENTER/EXIT bar code
above, then the bar code at left followed by digits from the
Alphanumeric characters in
Appendix D, Keypad
repre-
senting your desired character(s). End by scanning the ENTER/
EXIT bar c
ode again.
Make a mistake? Scan the CANCEL bar code to abort
and not save the entry string. You can then start
again at the beginning.
CANCEL
DEFAULT
10 = Quiet Interval of 100 ms
This feature applies ONLY to the Keyboard Wedge interface.
$CKBQI
~
To Next Page
Loading...
