Enter/Exit Programming Mode GS1 DataBar
TM
Expanded
104
Cobalto™ CO5300 Scanner
GS1 DataBar Expanded Set Length 2
This feature specifies one of the bar code lengths for GS1 DataBar Expanded Length
Control
. Length 2 is the maximum label length if in Variable Length Mode, or the second
fixed length if in
Fixed Length Mode. Length includes the bar code’s data characters only.
The length can be set from 1 to 74 characters. A setting of 00 specifies to ignore this length
(on
ly one fixed length). See
"Set Length 2" on page 241 for more detailed programming
instructions.
Select GS1 DataBar Expanded
Set Length 2 Setting
To configure this feature, scan the ENTER/EXIT bar
cod
e above, then the bar code at left followed by dig-
its from the Alphanumeric characters in
Appendix D,
Keypad
representing your desired character(s). End
by scanning the ENTER/EXIT bar code again.
Make a mistake? Scan the CANCEL bar code
to abort
and not save the entry string. You can then start
again at the beginning.
CANCEL
DEFAULT
74 = Length 2 is 74 Characters
$CXBL2
~
To Next Page
Loading...
