To Next Page

To Previous Page

Code 11 Enter/Exit Programming Mode

Product Reference Guide

163

Code 11 Length Control

This feature specifies either variable length decoding or fixed length decoding for the Code 11

symbology.

Variable Length —

For variable length decoding, a minimum and maximum length may be set.

Fixed Length —

For fixed length decoding, two different lengths may be set.

DEFAULT

Code 11 Length Control = Variable Length

Code 11 Length Control = Fixed Length

Code 11 Set Length 1

This feature specifies one of the bar code lengths for Code 11 Length Control. Length 1 is the

minimum label length if in

Variable Length Mode, or the first fixed length if in Fixed Length

Mode. Length includes the bar code’s check and data characters.

The length can be set from 2 to 50 characters. See

"Set Length 1" on page 239 for more

detailed programming instructions.

Select Code 11 Set Length 1 Setting

To configure this feature, scan the ENTER/EXIT bar

cod

e above, then the bar code at left followed by dig-

its from the Alphanumeric characters in

Appendix D,

Keypad

representing your desired character(s). End

by scanning the ENTER/EXIT bar code again.

Make a mistake? Scan the CANCEL bar code

to abort

and not save the entry string. You can then start

again at the beginning.

CANCEL

DEFAULT

04 = Length 1 is 4 Characters

$CC1LC00

$CC1LC01

$CC1L1

Datalogic Cobalto C05300 User Manual

Questions and Answers: