Enter/Exit Programming Mode Keyboard Send Control Characters
38
Cobalto™ CO5300 Scanner
Keyboard Send Control Characters
This feature is used by the Keyboard Wedge and USB Keyboard interfaces. It specifies how the
scanner transmits ASCII control characters to the host. Reference
Appendix E, Scancode
Tables
for more information about control characters.
Options are as follows:
Send Ctrl+Key —
ASCII characters from 00H to 0x1FH inclusive are transmitted in the format
Ctrl+Key. Special keys are available in the range from 81H to A1.
Send Ctrl+Shift+Key —
The behavior is the same as above, but control keys are sent in the
format Ctrl+Shift+Keys.
Send Special Function Key —
Send characters between 00H and 1FH according to the special
function key mapping table (see Scancode
Table 28 on page 273). This is used to send keys
that are not in the normal ASCII set. A unique set is provided for each available scancode set.
DEFAULT
Keyboard Send Control Characters = Send Ctrl+Key
Keyboard Send Control Characte
rs = Send Ctrl+Shift+Key
Keyboard Send Control Characters = Send Special
Function Key :
$CKBSC00
$CKBSC01
$CKBSC02
To Next Page
Loading...
Need help?
General
