Audio Jingle Enable Enter/Exit Programming Mode
Product Reference Guide
67
Audio Jingle Enable
This option determines whether the scanner will sound predefined “Jingles
1
” or traditional
beep sounds to indicate good read and power-up events.
See the following two parameters (starting on
page 68) to select which preloaded Jingle to
sound upon power-up or good read events.
Audio Jingle = Disable (Use traditional beep sounds)
Audio Jingle = Enable Jingles
1. A “Jingle” is a short, user-defined tune uploaded via Datalogic Aladdin™ configuration software.
$CAUEN00
$CAUEN01
To Next Page
Loading...
Need help?
General
