Enter/Exit Programming Mode Case Conversion
56
Cobalto™ CO5300 Scanner
Case Conversion
This feature allows conversion of the case of all alphabetic characters to upper or lower case.
NOTE
DEFAULT
Case Conversion = Disable (no case conversion)
Case Conversion = Convert to upper case
Case Conversion = Convert to lower case
Case conversion affects ONLY scanned bar code data, and does not
affect Label ID, Prefix, Suffix, or other appended data.
Character Conversion
Character conversion is an eight byte configuration item. The eight bytes are 4 character pairs
represented in hexadecimal ASCII values. The first character in the pair is the character that
will be converted. The second character in the pair is the character to convert to. If the
character to convert in a pair is FF, then no conversion is done. See
"Character Conversion"
on page 236 for more detailed programming instructions.
Configure Character Conversion
DEFAULT
0xFFFFFFFFFFFFFFFF(N
o character conversion)
$CLFCA00
$CLFCA01
$CLFCA02
$CLFCH
To Next Page
Loading...
Need help?
General
