Enter/Exit Programming Mode ACK NAK Options
28
Cobalto™ CO5300 Scanner
ACK NAK Retry Count
This feature specifies the number of times the scanner retries a label transmission due to a
retry condition. The selectable range is from 1 to 254 retries. A selection of 0 disables the
count, and a selection of 255 specifies unlimited retries. See
"ACK NAK Retry Count" on
page 223
for more detailed programming instructions.
Select ACK NAK Retry Count Setting
To configure this feature, scan the ENTER/EXIT bar
cod
e above, then the bar code at left followed by dig-
its from the Alphanumeric characters in
Appendix D,
Keypad
representing your desired character(s). End
by scanning the ENTER/EXIT bar code again.
Make a mistake? Scan the CANCEL bar code
to abort
and not save the entry string. You can then start
again at the beginning.
CANCEL
DEFAULT
$CR2AR
~
To Next Page
Loading...
Need help?
General
