Code 128 Enter/Exit Programming Mode
Product Reference Guide
129
Code 128 Set Length 2
This feature specifies one of the bar code lengths for Code 128 Length Control. Length 2 is
the maximum label length if in
Variable Length Mode, or the second fixed length if in Fixed
Length
Mode. Length includes the bar code’s data characters only.
The length can be set from 1 to 80 characters. A setting of 00 specifies to ignore this length
(on
ly one fixed length). See
"Set Length 2" on page 241 for more detailed programming
instructions.
Select Code 128 Length 2 Setting
To configure this feature, scan the ENTER/EXIT bar
cod
e above, then the bar code at left followed by dig-
its from the Alphanumeric characters in
Appendix D,
Keypad
representing your desired character(s). End
by scanning the ENTER/EXIT bar code again.
Make a mistake? Scan the CANCEL bar code
to abort
and not save the entry string. You can then start
again at the beginning.
CANCEL
DEFAULT
80 = Length 2 is 80 Characters
Code 128 Stitching
This option enables/disables stitching for Code 128 labels. When parts of a Code 128 bar code
are presented to the scanner with this feature enabled, the bar code parts will be assembled
by the scanner’s software, and the data will be decoded if all bar code proofing requirements
are met.
Code 128 Stitching = Disable
Code 128 Stitching = Enable
$CC8L2
~
$CC8ST00
$CC8ST01
To Next Page
Loading...
