Product Reference Guide
15
Chapter 3
Configuration Using Bar Codes
This and following sections provide programming bar codes to configure your scanner by
changing the default settings. For details about additional methods of programming, see
"
Customizing Configuration Settings" on page 11.
NOTE
You must first enable your scanner to read bar codes in order to use this
section. If you have not done this, go to
Setup, starting on page 5
and
complete the appropriate procedure.
Configuration Parameters
Once the scanner is set up, you can change the default parameters to meet your application
needs. Refer to "
Resetting the Product Configuration to Defaults" on page 13 for initial
configuration in order to set the default values
and select the interface for your application.
The following configuration parameters are divided into logical groups, making it easy to find
the
desired function based on its reference group.
Interface Configuration:
• "RS-232 ONLY Interface" on page 19
• "RS-232/USB-COM Interfaces" on page 23
• "Keyboard Interface" on page 33
• "USB-OEM Interface" on page 43
Parameters common to all interface applications:
• "Global Prefix/Suffix" on page 46
• "
Data Format" on page 45 offers advanced configuration options for customization of
scanned data output.
• "
Reading Parameters" on page 57 control various operating modes and indicators
status functioning.
Symbology-specific parameters:
"Symbologies" on page 79 defines options for all symbologies and provides the
programming bar codes necessary for config
uring these features.
To Next Page
Loading...
