NOTE
You must first enable your scanner to read bar codes in order to use this
section. If you have not done this, go to
Setup, starting on page 5
and
complete the appropriate procedure.
Enter/Exit Programming Mode Configuration Parameters
16
Cobalto™ CO5300 Scanner
To program features:
1. Scan the ENTER/EXIT PROGRAMMING bar code, available at the top of each program-
ming page, when applicable.
2. Scan the bar code to set the desired prog
ramming feature. You may need to cover
unused bar codes on the page, and possibly the facing page, to ensure that the scanner
reads only the bar code you intend to scan.
3. If additional input param
eters are needed, go to Appendix D, Keypad, and scan the
appropriate characters from the keypad.
NOTE
Additional information about many features can be found in the “References”
chapter.
If you make a mistake before the last character, scan the CANCEL bar code to
abort an
d not save the entry string. You can then start again at the beginning.
4. Complete the programming sequence by scanning the ENTER/EXIT PROGRAMMING bar
code to exit Programming Mode.
For more detailed descriptions, programming information and examples for setting selected
con
figuration items, see
References, starting on page 217.
To Next Page
Loading...
Need help?
General
