Codablock F Enter/Exit Programming Mode
Product Reference Guide
197
Codablock F Set Length 1
This feature specifies one of the bar code lengths for Codablock F Length Control. Length 1
is the minimum label length if in
Variable Length Mode, or the first fixed length if in Fixed
Length
Mode. Length includes the bar code’s data characters only.
The length can be set from 003 to 255 characters. See
"Set Length 1" on page 239 for more
detailed programming instructions.
Select Codablock F Length 1 Setting
To configure this feature, scan the ENTER/EXIT bar
cod
e above, then the bar code at left followed by dig-
its from the Alphanumeric characters in
Appendix D,
Keypad
representing your desired character(s). End
by scanning the ENTER/EXIT bar code again.
Make a mistake? Scan the CANCEL bar code
to abort
and not save the entry string. You can then start
again at the beginning.
CANCEL
DEFAULT
003 = Length 1 is 3 Characters
$CCFL1
~
To Next Page
Loading...
Need help?
General
